Follow the guides below to configure your hardware such as sensors, room panels, billboards and usb-dongles. For instructions regarding how to physically install the hardware please check out the On Site Installation Section.
Room Panel
Billboard
- Add billboard configuration.
- Add billboards.
- To get the billboard position, please login to billboards (instruction below) and long click on the location of the billboard to get the coordinates.
You can test (and retrieve the billboard position) the billboard by opening the billboard URL in your browser (Chrome, Firefox, Edge, Safari). The URL should be something similar to this: https://<YourCompany>-web.flowscape.se/web3d/
Login to billboard using the device credentials you setup in step 3 and select till billboard session you created earlier.
Sensors
Add sensors/wireless device. Please follow this guide for adding sensors/wireless device by any of the following providers:
- LoRa sensor
- Busy Light
- Helvar (Digidim)
- Yanzi
- Please note, for Yanzi sensors you need to add the sensor ID with the following appendix:
- Yanzi Mini: -3-Motion (i.e. EUI64-D0CF5EFFFE7BAAAA-3-Motion)
- Yanzi Presence/Motion: -4-Motion (i.e. EUI64-D0CF5EFFFE7BAAAA-4-Motion)
- Please note, for Yanzi sensors you need to add the sensor ID with the following appendix:
Desk Dongle
- Add Identifier - dongle ID for each desks.
Comments
0 comments
Please sign in to leave a comment.