Resetting the Panel
- Press Power + Volume Down buttons on the back of the panel simultaneously.
- Enter the password (default: "1234"; test panels may use "14471447").
- Navigate to Settings > System Tools > Factory Reset.
- Confirm the factory reset.
- Re-enter the password from Step 2.
- Wait a few minutes for the panel to reset.
Preperations
1. Prepare Files:
- Download the APK file "3.7.0-kit-kat" from this page.
- Download the root certificate from ISRG Root X1 Certificate.
- Transfer both the APK and certificate files to a USB drive.
2. Initial Setup After Reset:
- Turn on the panel and start the configuration process.
- On Security Settings, click Skip.
- On Network Settings, select Ethernet and click Next (ensure Ethernet is connected).
- On Connection Type, select DHCP and click Next.
- On Signage Display Settings, select Manual Setup and click Next.
- On General Information, click Next.
- On Remote Control, select Skip.
- On Clone Media Files into Internal, click Skip.
- On Setup Completed, click Finish.
Installing the Certificate
- Enter the settings menu by pressing Power + Volume Down buttons on the back of the panel.
- Log in using the password (default: "1234").
- Navigate to Settings > Security.
- Select Install from SD card.
- Locate the root certificate file on the USB drive and select it.
- Assign a name to the certificate (e.g., "Isrg").
- If prompted, set up a PIN or password to complete the installation.
Installing the Flowscape App
- Return to the main menu.
- Select Apps > File Manager.
- Navigate to mnt > usb_storage > USB_DISK 1.
- Locate the APK file and select it.
- Scroll to the bottom of the installation page and select Install.
- Wait for the installation to complete (approximately 10-15 seconds).
- Once installed, select Open to launch the app.
Comments
0 comments
Article is closed for comments.